First, just as a test if I succeed

Moderátor: sakulajda

Re: First, just as a test if I succeed

Příspěvekod Edwin » 01 bře 2014, 19:12

Thus , very slowly , there is next to a lot of other work here too progress .

Now I have the same time my new press frame fully utilized and created two forms in it.

Obrázek

Obrázek

Obrázek

Obrázek

And so I now have three forms for casting the tracks , which is still significantly speed things up .

Obrázek

So I started with the drive wheel . For this I must first find the perfect teeth and that I make from my experiences with pattern discs . The first I took over after a dimension of an original drawing and milled aluminum disc as such . On the side is for size comparison , the drive wheel of a tiger in 1 / 16th

Obrázek

And immediately encounter each theory and practice. An error of only 0.3 mm per tooth in the width and the toothing does not fit , although located in the Tolerance of the drawing.

Obrázek

I know however, to what extent I can not rely on these drawings and for what tracks ( 360mmm , or 400mm width) was thought the ring gear . There was quite small differences .
But as there is no great effort to mill a new disk and try until it fits snugly and can be applied to the Master of the drive wheel .
APAMOTEC Model technologie v detailu
Uživatelský avatar
Edwin
PzKpfw IV
PzKpfw IV
 
Příspěvky: 248
Registrován: 17 srp 2013, 22:21
Bydliště: Rheinland Pfalz Germany

Re: First, just as a test if I succeed

Příspěvekod Edwin » 02 bře 2014, 15:47

Slightly revised to correct the pitch and the intervention in the chain.

Obrázek

So I can now begin the drive to draw in 3D.
APAMOTEC Model technologie v detailu
Uživatelský avatar
Edwin
PzKpfw IV
PzKpfw IV
 
Příspěvky: 248
Registrován: 17 srp 2013, 22:21
Bydliště: Rheinland Pfalz Germany

Re: First, just as a test if I succeed

Příspěvekod sourekv » 02 bře 2014, 16:09

Hi Edwin,
complexity of your work is amazing.
From machining parts to casting.
Great and inspirational.
Vlada
ahoj
Mysleli jsme to dobře, ale dopadlo to jako vždycky
Uživatelský avatar
sourekv
PzKpfw V - Panther
PzKpfw V - Panther
 
Příspěvky: 791
Registrován: 22 zář 2009, 21:49
Bydliště: Praha

Předchozí

Zpět na StuG III

Kdo je online

Uživatelé procházející toto fórum: Žádní registrovaní uživatelé a 1 návštěvník

cron

x