http://www.elmod.eu/pdf/PC-Configurator ... tgh7mvikm3
Firmware Update
ElMod modules marked "BL" (delivered as of December 2011) can be transferred to the PC Configurator on the most recent software version.
Your module should ElMod not have this property, please contact us at
support@elmod.eu.
To transfer to a different software version on the ElMod module must be addressed as follows:
:
+
Switch the ElMod module and the wireless remote control
+
IMPORTANT: Disconnect the chain motors and the tower of the electronics connector
+
Make sure that the battery is charged
+
Hold the setup button while turning the ElMod module again. The location of the set-up button is shown in the instructions for each module.
+
When the LED flashes three times, then release the button
+
PC Configurator detects the programming mode automatically. The status bar is a red button that says "Update" visible
+
Press the button and read carefully the instructions
+
Select the desired software version, which will be played out.
The current software version can be downloaded free from our website at
http://www.elmod.eu. You can use stored software versions often
transferred to the module.
After the transfer, the module will automatically restart and repeat the process at any time