And on it goes with the tests.
First, the result with the purchased software
Here are the pressures.
The result is first times sobering , but I also had no miracles expected , since I do not yet know the program and also not made any , necessary for the printer adjustments have . In each case, the surface is significantly worse and what you can not see on the picture is too small a flow ( material feed) which too little PLA comes on to the part which can be seen especially in the non-closed ring ..
In such settings, but one has to grope and can not expect miracles.
Then I once removed the support of both parties and this result is not yet satisfactory, although this was relatively easy to remove.
So I created the G- code again revised the purchase program . A little more flow, a higher printing speed which the printing time shortened by 3 hours and a finer support.
Und weiter geht es mit den Versuchen.
Zuerst das Ergebnis mit der gekauften Software
Hier noch beim Druck.
Das Ergebnis ist zuerst mal ernüchternd, aber ich hatte auch keine Wunder erwartet, da ich das Programm ja noch nicht kenne und auch noch keine, für dem Drucker notwendigen Anpassungen gemacht habe. In jeden Fall ist die Oberfläche deutlich schlechter und was man auf dem Bild nicht erkennen kann ist ein zu geringer Flow ( Materialvorschub) wodurch zu wenig PLA auf das Teil kommt was vor allem am nicht geschlossenen Kranz zu sehen ist..
An solche Einstellungen muß man sich aber herantasten und kann keine Wunder erwarten.
Dann habe ich mal den Support beider Teile entfernt und auch dieses Ergebnis ist noch nicht zufriedenstellend, obwohl dieser relativ einfach zu entfernen war.
Also habe ich den G-Code nochmal beim Kaufprogramm überarbeitet. Etwas mehr Flow, eine höhere Druckgeschwindigkeit was die Druckzeit um 3 Stunden verkürzte und ein feinerer Support.
Das war heute früh das Ergebnis.
Die Oberflächen sind jetzt geschlossen, obwohl immer noch etwas zu wenig Flow da zu sein scheint und es ist relativ glatt. Die ganzen Perlen an der Oberfläche konnte man fast abkehren was also auch nicht stört.
Hier auch die drei Teile zum Vergleich nebeneinander.
So langsam nähere ich mich einen brauchbaren Ergebnis.
That was this morning the result.
The surfaces are now closed , although still seems a bit too little flow to be there and it is relatively smooth. All the beads on the surface could almost turn away so what does not hurt .
Here also the three parts to compare side by side.
So slowly I approach a useful result .